Serv-Ware DD61-1-HC 61" Draft Beer Dispenser, 1 Tower, 2 Faucets, 14.16 Cu. Ft., 115V

If you need more keg room but only one pour point, the Serv-Ware DD61-1-HC is worth a look. This 61-inch draft beer dispenser carries a single tower with two faucets over a roomy refrigerated cabinet, so you can keep spare kegs cold and ready for a quick changeover. Bars and restaurants that go through a lot of one or two beers will appreciate it.

The cabinet holds 14.16 cu. ft. at 33°F – 41°F, cooled by a 2/5 HP compressor with R290 hydrocarbon refrigerant. It plugs into a standard 115V outlet (NEMA 5-15P) and draws only 3 amps. Overall size is 61-1/16" W x 24-3/8" D x 42-1/8" H.

What you will notice in day-to-day use

• Fits the kegs you buy. The interior is designed to take a variety of keg sizes, including half-barrel, quarter and slim quarter kegs.
• Accurate temperature. An electronic thermostat with a digital LED display, located inside the cabinet, makes it easy to check and set the temperature.
• Less foam, less waste. A 3" diameter insulated stainless steel beer column is designed to carry cold air up to the tower, which helps reduce foaming and the beer you lose to it.
• Easy to keep running. The installation board removes for quick access to the condenser coil, and the magnetic gaskets can be swapped without tools.

Specifications

Before it arrives

• Power: a standard 115V grounded outlet with a NEMA 5-15P receptacle.
• Location: set it indoors in a climate-controlled area away from heat sources and leave room behind and around it for airflow.
• Casters: the casters ship loose, so fit them before moving the cooler into place.
• Delivery: shipping weight is about 320 lb; measure doorways against the 61-1/16" x 24-3/8" footprint.

Warranty

Three years parts and labor on the entire unit (United States, commercial use), plus an additional five years on the compressor (part only), from Serv-Ware.

Specifications per Serv-Ware data; subject to change by the manufacturer.