MagiKitch'n APM-RMB-672 72" Low Profile Countertop Radiant Charbroiler, 16 Burners, 240,000 BTU

Six feet of open flame is a statement piece for a steakhouse, a grill-forward restaurant or a high-volume burger kitchen, and the MagiKitch'n APM-RMB-672 delivers it without eating vertical space. This is a low profile countertop charbroiler built to sit on a work table, a counter or a properly insulated refrigerated or freezer base, so your proteins can live right underneath the grill.

Sixteen all stainless steel burners put out a combined 240,000 BTU/hr, and each one fires a V-shaped stainless radiant that spreads the heat evenly across 1,704 square inches of cooking area. Individual front controls, spaced roughly every 4 to 4-1/2 inches, let you set up hot and cooler zones across the full 72" width.

What you will notice in day-to-day use

• Zones that match your menu. With 16 burners each on its own control, you can sear steaks on one end, finish chicken in the middle and hold vegetables at the other.
• Even radiant heat. A V-shaped radiant above each burner turns flame into steady, even heat and catches drippings for that charbroiled flavor.
• Grids that stay flat. The free floating 1/2" steel rod top grid expands and contracts without warping, and the E-Z Tilt design drains grease into the front trough.
• Less heat in the line. A fully insulated, double walled cabinet with stainless steel on all four sides keeps more heat on the food and off your cooks.
• Room to work. A 6" stainless service shelf with towel bar runs along the front, and three crumb trays collect debris for easier cleanup.

Choosing your setup

Gas type: this charbroiler is offered for natural gas or liquid propane (LP); choose the gas your kitchen uses above. The 240,000 BTU/hr rating is the total input. A 3/4" gas regulator ships unattached and must be installed on the supply before the gas line is connected. Supply and burner pressures are below.

The APM series also comes in 24" to 72" widths, radiant or ceramic coal, and in high-output (-H) versions.

Specifications

Before it arrives

• Gas: have a qualified installer fit the supplied 3/4" regulator, then connect to the 3/4" NPT inlet. Size the supply line to hold burner pressure with every gas appliance on the line running.
• Ventilation: install under a commercial hood following local code; do not block the flue or place hood drains over it.
• Clearance: keep 6" at the sides, 8" at the rear and 4" at the floor from combustible materials (0" sides and rear to non-combustible), and allow a 30" aisle in front. Indoor use only.
• Delivery: ships crated at about 1050 lb (36" x 48" x 84" H x W x L), so plan for a liftgate or dock and enough hands to set it in place.

Warranty

2 years parts and labor from MagiKitch'n.

Specifications per MagiKitch'n data; subject to change by the manufacturer.