Dukers DCGT24 24" Thermostatic Countertop Gas Griddle, 1" Steel Plate, 2 Burners, 52,000 BTU

Thermostatic control is what lets a griddle cook the same way at 7 a.m. and at the height of the lunch rush. The Dukers DCGT24 puts that control on a compact 24-inch countertop griddle, a good fit for cafes, delis and smaller lines that want consistent results from every cook.

Two 26,000 BTU/hr burners (52,000 BTU/hr total) heat a 1" thick polished steel plate, and each 12" section has its own thermostat adjustable from 250°F to 500°F. The cooking area is 23-7/8" x 20-1/2".

What you will notice in day-to-day use

• A plate that holds its heat. The 1" thick polished steel plate stores plenty of heat, so the surface bounces back quickly after you load it with cold product.
• Set it and trust it. Each 12" section has its own thermostat, adjustable from 250°F to 500°F, so the plate holds the temperature you chose instead of drifting during service.
• Pilots stay ready. Each burner has a standby pilot, so the griddle is always ready to come up to heat.
• Less mess at closing. Grease runs into a full-length seamless drip pan that is simple to remove and clean.
• Built to work on any counter. Stainless steel inside and out, with adjustable stainless legs that set the height anywhere from 15-1/4" to 17-5/8" and level it on an uneven surface.

Choosing your setup

Gas type: the griddle ships set up for natural gas, with an LP conversion kit included. Choose the gas your kitchen uses above; the ratings and gas pressures for each are in the table.

Specifications

Before it arrives

• Gas: 3/4" NPT inlet; a qualified installer should connect it and fit the LP kit if needed.
• Ventilation: install it under a commercial hood following your local code.
• Counter or stand: 24" wide and 28-1/2" deep, about 184 lb, so use a sturdy, non-combustible counter or stand and keep the clearances in the installation manual.

Warranty

1 year parts and labor from Dukers.

Specifications per Dukers data; subject to change by the manufacturer.